Hearth-and-home-technologies Hudson Bay Direct Vent Gas Appliance HUDBAY-FS Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 49
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
10/08
Page 29Quadra-Fire • Hudson Bay • 7003-121 Rev. i
Figure 8.8 Keeping the baf e elevated with your free hand,
put the right side brick into position. Rest the baf e on the
right side brick.
Figure 8.9 Still holding the baf e in place, install the left brick
into position.
E. Brick Set Installation
Figure 8.7 To install the baf e, slide it in at an angle and rotate
upward parallel with the rebox. Place baf e up against
the heat exchangers in top of rebox. Holding against heat
exchangers, slide baf e towards front of appliance.
D. Grille Installation
Figure 8.5 Following instructions stated above, remove the
door of appliance.
Remove the four screws (two at each end) holding the grille
in place. Lift up to remove.
Install the new grille by reversing the removal instructions.
NOTE: Clean glass and gold or nickel plating with glass
cleaner and a soft cloth, wiping off all ngerprints prior to rst
re to prevent permanent staining.
Figure 8.6 The pilot shield has to be removed to install or
remove the brick refractory. Removal of the bracket requires
removing two screws.
Pilot Bracket
Pilot
Shield
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Commentaires sur ces manuels

Pas de commentaire